Want to Pass 300-320 Exam In Next HOURS? Download Now →
February 12, 2018

Ideas to 300 320 arch pdf


Free Instant Download NEW 300-320 Exam Dumps (PDF & VCE):
Available on: https://www.certshared.com/exam/300-320/


Q131. Which two of these are correct regarding the recommended practice for distribution layer design? (Choose two.) 

A. use a redundant link to the core 

B. use a Layer 2 link between distribution switches 

C. never use a redundant link to the core because of convergence issues 

D. use a Layer 3 link between distribution switches with route summarization 

E. use a Layer 3 link between distribution switches without route summarization 

Answer: A,D 


Q132. Which option does the FabricPath technology use to create loop-free Layer 2 networks? 

A. STP 

B. TTL 

C. fabric tags 

D. FSTP 

Answer:


Q133. What is the correct state between two BGP peers that are neighbors? 

A. active 

B. operational 

C. established 

D. up 

Answer:


Q134. A network engineer must perform posture assessments on Cisco ASA remote access VPN clients and control their network access based on the results. What mode is the Cisco best practice NAC deployment design for this situation? 

A. Layer 2 in-band real IP gateway mode 

B. Layer 2 out-of-band real IP gateway mode 

C. Layer 3 in-band virtual gateway mode 

D. Layer 3 out-of-band virtual gateway mode 

Answer:


Q135. Summary address blocks can be used to support which network application? 

A. QoS 

B. IPsec tunneling 

C. Cisco TrustSec 

D. NAT 

E. DiffServ 

Answer:


Q136. From a design perspective which two of the following OSPF statements are most relevant? (Choose two) 

A. OSPF stub areas can be thought of as a simple form of summarization 

B. OSPF cannot filter intra-area routes 

C. An ABR can only exist in two areas - the backbone and one adjacent area 

D. Performance issues in the Backbone area can be offset by allowing some traffic to transit a non-backbone area 

E. The size of an area (the LSDB) will be constrained by the size of the IP MTU 

Answer: A,B 


Q137. Support of vPC on the Cisco Nexus 5000 access switch enables various new design options for the data center Access layer, including which of the following? 

A. The vPC peer link is not required for Access layer control traffic, and can instead be used to span VLANs across the vPC access switches 

B. A single switch can associate per-interface with more than one vPC domain 

C. vPC can be used on both sides of the MEC, allowing a unique 16-link EtherChannel to be built between the access and aggregation switches 

D. Allows an EtherChannel between a server and a access switch while still maintaining the level of availability that is associated with dual-homing a server to two different access switches 

Answer:


Q138. Which two design recommendations are most appropriate when EIGRP is the data center core routing protocol? (Choose two.) 

A. Summarize data center subnets. 

B. Advertise a default route into the data center core from the aggregation layer. 

C. Tune the EIGRP timers to enable EIGRP to achieve quicker convergence. 

D. Adjust the default bandwidth value to ensure proper bandwidth on all links. 

Answer: A,B 


Q139. Which technology fulfills these requirements? 

. Utilize a connection that must support a range of traffic, voice, video, and data. 

. This traffic must also support transmission via a fixed blank 53-byte cell. 

A. PPP 

B. Frame Relay 

C. ATM 

D. MPLS 

E. X.25 

Answer:


Q140. The direction of the flow of multicast traffic is based on which protocol? 

A. PIM 

B. IGMP 

C. underlying IGP 

D. MSDP 

Answer: